Search

7 Jun 2010: Personal communication from Paul Weitzel, Babcock & Wilcox, Barberton, OH and Mark Palkes, Alstom Power Co., Windsor, CT, May 24, 2002. ... Results of steam oxidation tests at 650C (1200F) for times up to 2000 h have been reported for several austenitic

7 Jun 2010: weld metal. E ffect of PW H T con dition s on no tch to ug hnes s of P 23 an d P 24 S A-w eld m etal.

7 Jun 2010: 7). A steel-grade-specific difference ranging from around 7 GPa to 24 GPa was determined for the test temperature interval from -40 C to 100 C.

7 Jun 2010: However, if the actual irrational orientation is used then there will always be 24 variants. ... austenite. P thus completely defines the deformation system, and there will in general be 24 different variants.

7 Jun 2010: 0.24 0.38 0.53 0.031 0.008 12.0 1.21 - 0.31 - <0.02 0.034 0.63 0.006 -. Inconel 706 0.014 <0.02

7 Jun 2010: As a matter of interest, the segregation profile. Coates has discussed this in a very thorough paper on diffusional transformations [24]. ... 26 (1978) 1833.23. Idem, Met. Sci 13 (1979) 146.24. D. E.

7 Jun 2010: 485 535-585 0.766-0.829 22.0-24.8 11770 40.9-63.9E420C bm 450 595 0.756 30.7 18266 – Union K56 wm 500 560-720

7 Jun 2010: initiation of transformation by generalising equation 12 as follows [23, 24]:. ... Bhadeshia: Metal Science 16 (1982) 159–165. [24] J. L. Lee, H.

7 Jun 2010: Isothermal experiments to measure the bainite-start tem-perature (BS) were conducted at 25C intervals beginningwith 250C and raising the temperature until bainite wasnot observed over a 24 h period.

7 Jun 2010: SEAKI: Nippon Steel Technical Report,No. 90, (2004), p. 20-24. [11] J.

8 Oct 2010: In our latest study, investigations into the microstructure – toughness relation were performed on HFI welded (non-HIC) X65 pipes with a diameter of 24”and the findings are described here. ... a) (b) (c). Figure 24: {100} Pole figures of (a) base

7 Jun 2010: Traditional mills continued to be built too: United was supplier of 24 electrically driven handmills for Youngstown Sheet and Tube Company, Indiana Harbor Works which were obsolete once installed (Hogan, 1971,

7 Jun 2010: w is given by. w. 1{ 1{4 1{e{. v. kT. 24. ... 24. 35. (4). The deviation from Henrian behaviour is all containedin the last term of equation (3), so.

7 Jun 2010: austenitic and polycrystalline. An applied stress can stimu-late martensitic transformation, but there are 24 possiblecrystallographic variants of martensite that can form. ... Mori and I. Tamura: Mater. Sci. Eng., 24. (1976), 85.9) H.

7 Jun 2010: There is a great deal of effort devoted to the designof welding alloys which compensate for the thermal contraction induced stresses as the weld cools[24–33]. ... Acta Metallurgica, 11:1291–1301, 1963. [24] A. Ohta, N. Suzuki, Y. Maeda, K.

7 Jun 2010: For example, even after 24 h at 475C thezirconium remaining in solid solution will only havediffused. ... the upper limit of.0.2 J m22 expected for afully coherent nucleus [24].

7 Jun 2010: Ti=0.03 B=0.0024. 3.0Cr1.5Mo 0.1 0.2 1.0 0.1 1.5 3.0 0.1. 3.5NiCrMoV 0.24 0.01 0.20

7 Jun 2010: 0.1. 0.12. 0.14. 0.16. 0.18. 0.2. 0.22. 0.24. 0.26. 0 100 200 300 400 500. ... 0.1. 0.12. 0.14. 0.16. 0.18. 0.2. 0.22. 0.24. 0.26. 0.28. 13000 14000 15000 16000 17000.

7 Jun 2010: BH [MPa] = 77 11.24[(T (C) – 200)/30] 3.71[(t(s)/60 – 8)/6] (1).

7 Jun 2010: M12. Cer. t. 0,1 0,26 0,53 0,028 0,02 - 11,93 1,01 1,02 - 0,24 0,04 - - -. Nor. m 0,07. 0,14. <0,5

7 Jun 2010: Steel A 0.087 0.245 0.51 0.017 0.016 0.035 0.021 Steel B 0.1170 0.24 1.47 0.058 0.0144.

7 Jun 2010: Each austenite grain can transform into 24 different crystallographic variants of the plates.

7 Jun 2010: 0. 50. 100. 150. 200. 250. 300. 350. 400. 450. 18 20 22 24 26 28PLM (T273)(20logt)/1000.

7 Jun 2010: Austenite grain structureAustenite grains are conveniently represented as a stackof identical, space filling Kelvin tetrakaidecahedra,24–28. ... Mater.,. 2002, 46, 375–378. 24. E. E. Underwood: ‘Quantitative stereology’; 1970, Reading, MA,.

7 Jun 2010: Symp. On High Strength Steel, Verdal,. Norway, April 23-24, 2002. [4] Lord M.: Welding in the World, 41 (1998) p.

26 Jul 2010: The phase field methodhas no such detail, but rather relies on a fundamentalapproximation of the thermodynamics of irreversibleprocesses,24–27 that the flux describing the rate isproportional to the force responsible ... ical application’, Phys. Rev.

7 Jun 2010: 4) Figure 23 shows the FE-Models with a meshing according to figure 24 that produce. ... Figure 24: Meshing of FE-Model [6]. Figure 25: Force-deformation curves from test and from calculations [6].

7 Jun 2010: 24. R. Nandan, G. G. Roy, T. J. Lienert and T. ... K. D. H. Bhadeshia: Mater. Sci. Technol., 2008, 24, 128–135. 28.

30 Oct 2010: Martensite transformation starttemperatures were calculated using MTDATA [19] as described in [18, 20-24]. ... B. Olson: ‘Kinetics of FCC&BCC heterogeneous martensitic nucleation’, Acta Metall. Mater., 1994, 42, 3361–3370.24.

7 Jun 2010: 20 Va:2<FCC_A1> NORMAL 21 Cr:1<FE4N> NORMAL 22 Fe:1<FE4N> NORMAL 23 Mn:1<FE4N> NORMAL 24 C:2<FE4N> NORMAL 25 Cr:1<HCP_A3> ... 24> tcfe 298.15 6000.00 Cr:Cr:Fe<CHI_A12:24:10:24> tcfe 298.15 6000.00.

7 Jun 2010: 2 [24,25]. Fig. 2: The effect of some substitutional solutes (3 at.%) on the strength of otherwise purepolycrystalline iron as a function of the test temperature. ... After Leslie [24]. Fig. 4 shows some interesting typical data [24,25,26]: that whereas

7 Jun 2010: Deformation not only increases thedislocation density but also the amount of grain surface and grain edge per unit volume [18] andby cutting precipitates may force them to dissolve [19–24]. ... C1 3.98 x 10-1. -9.02 x 10-3. 9.24 x 10-2. 1.89 x 10-2.

7 Jun 2010: B 0.13 0.05 0.50 0.006 0.001 0.74 10.24 1.05 0.19 0.054 1.05 C 0.13 0.04 0.50

7 Jun 2010: and are dominated by the eg states. For the other impurities, the antibonding states form virtual bound states (VBS)24 near EF,. ... 24 V. A. Gubanov, A. L. Liechtenstein, and A. V. Postnikov, Magnetism and the Electronic Structure of.

7 Jun 2010: Sjostrom (E&FN Spoon, London, 1996) p. 491. 24) W.A. PYC, R.E.

7 Jun 2010: 15 1.41 0.36 0.38 0.11 15.99 4.710.065N 64.03 12.20 1.72 1.10 0.15 0.11 18.45 2.24.

7 Jun 2010: Materials Science andEngineering A, 434A:237–245, 2006. [24] H. K. D. H. ... Materials and Manufacturing Processes, 24:1–7, 2009. [28] M. S. Joo, J.

24 Nov 2010: Domains of steels withidentical properties. Materials and Manufacturing Processes 24, 53–58.

7 Jun 2010: direct observations of interstitial atom decoration of dislocation substructure (Figure 4) [23,24]. ... Paetke and D.V. Edmonds, Deformation of Polycrystals: Materials and Microstructure, Riso National Laboratory, Denmark, 1981, p 467-472 [24] A.R.

19 Sep 2010: 23 CRSI2 NORMAL PURE SUBSTANCE! 24 CHI_A12 NORMAL SUBLATTICE! 25 SIGMA NORMAL SUBLATTICE! ... MULTIPHASE OPTION? cls?a! CLSA KEYWORD NOT RECOGNISED! MULTIPHASE OPTION? cla abs p(23,24)!

7 Jun 2010: Austenite grain structureAustenite grains are conveniently represented as a stackof identical, space filling Kelvin tetrakaidecahedra,24–28. ... Mater.,. 2002, 46, 375–378. 24. E. E. Underwood: ‘Quantitative stereology’; 1970, Reading, MA,.

7 Jun 2010: 9 7.6 4.7 8.9 0.3 0.7ave 932 944 1067 1086 13.1 10.4 okstd 3.6 24.9 6.6 20.9 0.8

7 Jun 2010: 24. Figure 1.13 Combined test error depends on the number of models. ... dataset. Fig. F. gure 2.23 Di. Figure 2.24 D. Figure 2.25.

7 Jun 2010: Butt welds 2.82 3.13 2.67 3.02 Transverse stiffeners 5.20 6.03 4.24 6.20 Tab.

7 Jun 2010: Figure 6.24: SEM micrograph of 2 14Cr1Mo steel tempered at 600C for. ... The process is accelerated by tempering at 600C (Figure 6.24, Figure 6.25).

7 Jun 2010: 1184 Materials Science and Technology 2008 VOL 24 NO 10. ... Materials Science and Technology 2008 VOL 24 NO 10 1185.

7 Jun 2010: The points. represent experimental measurements [4]. Materials and Manufacturing Processes 24 (2009) 1-7. ... The points. represent experimental measurements [19]. Materials and Manufacturing Processes 24 (2009) 1-7.

7 Jun 2010: 1Institute for Materials Science, Welding and Forming, Materials Scienceand Welding Technology, Graz University of Technology,Kopernikusgasse 24, A 8010, Graz, Austria2Department of Materials Science and Metallurgy, University ofCambridge, Pembroke

7 Jun 2010: 24. The thick plate equation, which considers three-dimensional heat flow from apoint source states that the cooling rate.

7 Jun 2010: 346 Materials Science and Technology 2008 VOL 24 NO 3. parent phase is highly supersaturated with carbon. ... 24. B. Sonderegger and E. Kozeschnik: ‘Generalized nearest neighbor. – broken bond analysis of randomly oriented coherent interfaces in.