Search

12 Oct 2006: Load test results from jacked pilesinstalled closer than this recommended minimum spacingare presented. ... Fig. 1. Maintained load tests on square and circular cellfoundations! "! #. $ %#&. '&(). (%. &(. , (. (-. $ '. Fig. 2. Ground conditions at test

25 Aug 2006: whether these shear lap tests actually simulate the debonding mechanism of real beams. ... RILEM Report 5, Fracture Mechanics Test Methods for Concrete, RILEM, International Union of Testing and Research Laboratories for Materials and Structures, London,

11 May 2006: TOP SIDE. Figure 11. Test piece drawing (dimensions in mm). 7 of 12. ... First test-piece (a) hung for display (b) showing connectors at the back.

25 Jan 2006: Geotechnical Engineering Group. Abstract. In a series of model tests of construction processes in soft ground in the mini-drum centrifuge, it has been proved that both physical and numerical modelling ... Multiple tests and parametric studies have been

17 Feb 2006: Displacement (mm). Fo. rce. (N. ). Test. Abaqus. Figure 12: Response to horizontal tip loads. ... Displacement (mm). Fo. rce. (N. ). Test. Abaqus. 6. Figure 13: Response to vertical tip loads.

26 Jan 2006: In this research, the horizontal arching mechanism and lateral deformations of cantilever walls are investigated using centrifuge tests. ... A series of six tests was carried out at 45g and the panel widths and thicknesses around the model basement were

25 Aug 2006: This thesis describes dynamic centrifuge tests undertaken to try and increase understanding of three such remediation methods: containment walls, cemented zones and inclined, non-loadbearing micro-piles. ... Centrifuge tests with a simple SDOF frame

11 May 2006: To establish some facts about thebehaviour of TWF, Section III shows the results of some representative tests on flat, rectangular plates andon narrow strips. ... The specimens were clamped to a rigid support at one end and were held parallel and close

14 Dec 2006: Tests performed using different chemical compositions but under otherwise identical conditions demonstrated that the lubricant composition significantly affects the rate of build-up as well as the final magnitude of effective

2 Feb 2006: the existence of intermediate configurations where the path bifurcates. In this paper, we aim to developa simple and yet efficient analysis scheme that enables a designer to test for the existence

23 Feb 2006: A detailed experimental investigation of the stress-strain behaviour of kaolin was carried out using a computer controlled triaxial apparatus supplemented by tests in an oedometer.

11 Jul 2006: This is achieved by conducting a series of unconfined compression tests in wet-soil mixed specimens prepared both mechanically and using a laboratory-scale auger-mixing equipment.

23 Feb 2006: All test results presented in this section were obtained on 380 mm widemembranes with a height, between the supports, of 128 mm. ... Laser scanning frame. 3.2. Shear test apparatus. 3.3. Square membrane apparatus.

16 Nov 2006: Two series of centrifuge tests on plane-section tunnels in clay were conducted. ... Details of the centrifuge tests used in thevalidation of the proposed deformation mechanism are.

16 Nov 2006: These twoanalytical solutions have been validated against five pre-viously published centrifuge tests. ... Shear strain contoursFigure 7(a) shows the shear strain contours for test 2DP at.

2 Feb 2006: If bending and twisting are decoupled in theD matrix, then the test for positive definiteness reduces to (5.2).

25 Jan 2006: al. 1995). The aim of the test (test A) was to study the short-term behaviour and the ultimate bearing capacity of rigid foundations under vertical loads. ... direct simple shear tests) on a representative un-disturbed sample. The maximum incremental

11 May 2006: VI. Properties of Test Balloons. The geometric and material properties of a series of experimental balloons that have been investigatedas part of the ULDB development will serve in the following as

25 Jan 2006: The working strain is then deduced from the mobilised shear stress using raw test data. ... The BRICK model simulation allowed for deposition, erosion, and re-deposition, followed by a triaxial test to failure.

25 Jan 2006: The MSD method is used to back analyze tests on instrumented rigid square pads performed at the soft clay test site at Bothkennar in Scotland (UK). ... 3. BACK ANALYSIS OF LOADING TESTS ON A STIFF FOOTING AT BOTHKENNAR 3.1 Site Bothkennar soft clay test

23 Feb 2006: to reproducethe conditions that may exist at the beginning of a test. ... 5.1.1. Initial imperfections. Many different combinations of eigenmodes and scal-ing factors were considered to test the sensitivity of the results of the detailedwrinkling analysis

12 Jan 2006: 2 METHODOLOGY. 2.1 Ground conditions. This series of pile load tests was conducted during summer 2003 at the Takasu test site located in Kochi, Japan. ... Figure 2. Ground conditions at test site. Figure 3. Arrangement of test piles.

18 Jan 2006: 2.5 Test programme. A series of four tests was conducted, using two grain sizes and two densities as shown in Table 1. ... Table 1. Summary of tests Dry Voids Relative Test D50 density, ratio, density, φpeak ψpeak (mm) ρd (kg/m3) e ID CD 2.24 1687

18 Jan 2006: The solution to this drawback is to truncate only the test paf esm,nd. ... White et al.2003! report a precision better th0.05 pixels for test patches larger than 163 16 pixels in a varietof validation tests using GeoPIV.

12 Oct 2006: Vaterland 1, Oslo. Vaterland 1 is one of several test sections on the Oslo SubwaySystem. ... The writers show thatthe undrained DSS test gives good displacement predictions.Since triaxial tests are more commonly available in practice, fur-ther

15 Aug 2006: Also the stress path, i.e., therelationship between the different components of the effectivestress, is an interesting result of an undrained test, whereas it isusually imposed in dry tests. ... The result of an undrained test can, in principle, be

18 Jan 2006: 4) FE simulation of an undrained triaxial test was used toplot the representative stress–strain curve. ... deformation zones.(3) Determine the active and passive strengths mobilized. from compression and extension triaxial tests, respec-tively.

15 Aug 2006: will. Fig. 3. Comparison between pipe displacement and liquefaction frontadvance in Test TM01. ... standard soil tests. It is therefore assumed that the liquefied soil is.